Seabass jaw model

Hi appreciate if anyone can help me on this.  I am trying to make a seabass jaw/teeth model (i.e. just the mouth area but not the whole head) but couldn't figure out how to stick together the eight pieces of bones.  Anyone has any diagram/instruction that would help?  Do I need more than eight pieces (normally other fish like breams require just 8 pieces)?

Thanks in advance for help.

Hi appreciate if anyone can help me on this.  I am trying to make a seabass jaw/teeth model (i.e. just the mouth area but not the whole head) but couldn't figure out how to stick together the eight pi ...
stevenl_604 發表於 2009-5-15 18:53

                               
登錄/註冊後可看大圖

老兄！不如影張相上黎大家研究下啦~~

2# TEN69

Thanks for the reply.  Here's the photo:

The four pieces on top of the photo is for the upper part of the jaw and the four pieces on bottom of the photo is for the lower part.  However, I can't seem to fit the pieces together.  I've made bream's jaw model before the eight pieces fit together very well.

Not sure if I need more than the 8 pieces here.

2# TEN69

Thanks for the reply.  Here's the photo:

The four pieces on top of the photo is for the upper part of the jaw and the four pieces on bottom of the photo is for the lower part.  However, I  ...
stevenl_604 發表於 2009-5-16 19:06

                               
登錄/註冊後可看大圖

steven兄！
上面果排，尖果件調轉鋪係面……
下面果排，尖果件插入去………
可以參考下其他牙托
http://www.fishinghk.com/forum/viewthread.php?tid=33443&highlight=%E7%89%99

4# TEN69

Thanks for the advice~  However aftering looking into some seabass photos and eating a small seabass tonight, I think the upper part of the jaw should be done a bit differently.  I will try and post up the trial model soon...thanks!

5# stevenl_604

Done~ http://www.fishinghk.com/forum/viewthread.php?tid=35171&page=1&extra=