Hi appreciate if anyone can help me on this. I am trying to make a seabass jaw/teeth model (i.e. just the mouth area but not the whole head) but couldn't figure out how to stick together the eight pieces of bones. Anyone has any diagram/instruction that would help? Do I need more than eight pieces (normally other fish like breams require just 8 pieces)?
Hi appreciate if anyone can help me on this. I am trying to make a seabass jaw/teeth model (i.e. just the mouth area but not the whole head) but couldn't figure out how to stick together the eight pi ...
stevenl_604 發表於 2009-5-15 18:53
The four pieces on top of the photo is for the upper part of the jaw and the four pieces on bottom of the photo is for the lower part. However, I can't seem to fit the pieces together. I've made bream's jaw model before the eight pieces fit together very well.
The four pieces on top of the photo is for the upper part of the jaw and the four pieces on bottom of the photo is for the lower part. However, I ...
stevenl_604 發表於 2009-5-16 19:06
Thanks for the advice~ However aftering looking into some seabass photos and eating a small seabass tonight, I think the upper part of the jaw should be done a bit differently. I will try and post up the trial model soon...thanks!